Allow adequate space for proper ventilation. Environmental factors impact battery life. Elevated ambient temperatures, poor quality AC power, and frequent short duration discharges will shorten battery life. Do not use surge protectors or extension cords. Do not expect full battery runtime capability during this initial charge period. Connect equipment to the UPS. Connect the UPS to a two-pole, three-wire, grounded source. USB port: Connect to a computer to use power management software.
Serial port: Connect a serial port cable not supplied to use power management software. Ground Screw: Connect the ground leads on transient voltage devices to the chassis ground screw s , located on the rear panel of the UPS. The display interface can be configured to remain continuously illuminated or to extinguish after a period of inactivity to save electricity.
The display will illuminate and the UPS will beep to confirm Continuous Illumination mode is activated. While in Power Saving mode, the display will illuminate when a button is pressed. The display will extinguish after 60 seconds of inactivity. The UPS detects and reacts to line voltage distortions by transferring to battery backup power to protect connected equipment. In situations where either the UPS or the connected equipment is too sensitive for the input voltage level it is necessary to adjust the transfer voltage.
Be sure the UPS is turned off. The load capacity bar will flash on and off, to indicate the UPS is in Program mode. The UPS will beep to confirm the selection. When the UPS is in Sensitivity Configuration mode, the Sensitivity bar graph icons display the sensitivity level setting. See the examples here as a reference. Use this setting when connected equipment is sensitive to any minor fluctuations in voltage or waveform distortions.
Welcome to ManualMachine. Connect critical equipment to the Main Outlet Group. Connect peripheral equipment to the Switched Outlet Group. Use the Configuration menus to configure how the Switched Outlet Group will react in the even If the EPO switch or relay contacts are normally open, insert the wires from the switch or co Secure the wires by tightening the screws. If the EPO switch or relay contacts are normally closed, insert the wires from the switch or Insert a wire jumper between pins 1 and 2.
Secure the wires by tightening the three screws at Review the Troubleshooting section of the UPS manual to eliminate common problems. Note the model number and serial number, located on the rear of the unit, and the date of purc If the unit is under warranty, the repairs are free. Service procedures and returns may vary internationally. Refer to the APC Web site for country Pack the unit in its original packaging.
If this is not available, refer to www. Pack the unit properly to avoid damage in transit. Never use foam beads for packaging. Internal batteries may remain connected in the XLBP during shipment if applicable, not all un
0コメント